Krispy Limited
KRISPY K-LINE Box – K-Line to CAN Adaptor
KRISPY K-LINE Box – K-Line to CAN Adaptor
Couldn't load pickup availability
Connect a vehicle that uses K-Line diagnostics to a KrispyGauge or compatible CAN dash. The KRISPY K-LINE Box reads data through the vehicle’s diagnostic connector and sends it over a separate CAN bus using a configurable output protocol.
- K-Line inputs: ISO 9141, KWP2000, Subaru SSM, VAG KW1281, Mitsubishi MUT and BMW DS2.
- CAN outputs: OBD-II PIDs, Haltech, Link, MaxxECU, MegaSquirt, ECUMaster EMU, AEM Infinity and Holley EFI.
- Configure the module over Wi-Fi. It can also be configured to send supported ECU data to a factory K-Line dash.
Included in the box: 2 × JST XH4 cables with 4-pin connectors. The cables plug into the adaptor’s vehicle-side and CAN-side ports. The vehicle side connects to K-Line, switched 12 V and ground. The CAN side carries CAN High, CAN Low, 12 V and ground to a compatible gauge or dash. See the wiring guide below for pinouts.
Check your vehicle’s diagnostic protocol before ordering. K-Line is common on vehicles built before about 2008, and the changeover varies by model and market.
KrispyGauge wiring and setup guide · Vehicle compatibility guide
Share



