Carton (12) JLM-J04601C Underbody Coating (UBC) - Gravel & Rust Protection 1ltr

JLM J04601 Underbody Coating is a fast-drying, waterproof, resilient, oversprayable, sound-insulating and noise-reducing layer that provides protection against damage caused by chippings, such as gravel, grit salt or dirt. It also prevents rust and damage to vehicle underbody components, floor panels, wheel compartments, spoilers, doors, door sills and visible bodywork components.

JLM Underbody Coating is made from synthetic resin and hard (SBS) rubber, which means that it is durable, adheres well and dries rapidly. JLM Underbody Coating is thixotropic (pseudoplastic). This means that if you shake the can in which it is stored, the viscosity of the coating decreases, making it more liquid and therefore easier to apply by spraying. Once spraying is complete, the liquid immediately changes back into a gel. This enables it to be applied to the vehicle as a structured layer that adheres well to the underbody and forms a non-drip finish.

Once applied to the underbody, the coating forms a sealed, protective layer that is elastic and densely structured. JLM Underbody Coating is dust dry between 1 and 2 hours after application. Between 5 and 7 hours after application, the protective layer is dry to the touch. Once it has completely dried out after around 24 hours, the coating can be oversprayed using almost any brand or type of paint system, without any risk of the paint blending with the coating.

Applications:

JLM Underbody Coating can be used on all vehicles, such as cars, vans, campers, caravans, agricultural vehicles, trucks or trailers. The Underbody Coating is available in black; in a 500 ml spray can (item number J04603) and in a 1 litre can with screwed top (item number J04601).

Apply the coating using a compressor spray gun, operating at a working pressure of at least 3 and no more than 6 Bar. Once dry, coating residues are simple to remove using a solvent such as benzine or turpentine. Store JLM Underbody Coating in a cool and dry location. If stored unopened in its original packaging, JLM guarantees that the Underbody Coating can be kept for one year

Product Usage:

• Use at room temperature
• Stir before use
• Surface must be dry and clean, free from dirt, rust, grease etc
• Spray or brush an even layer on the object or surface to be coated
• Recommended thickness = approximately 0,5 mm at application
• Apply at least 2 layers Leave to evaporate/dry
• Before overpainting allow the coating to be completely dried
• Do not coat the exhaust, brake systems, or motor parts
• For high corrosion protection bare metal should be treated with an anti-corrosion primer prior to the use anti gravel
• Can be removed with aromatic solvents as white spirit, boiling point naphtha, xylene, etc. Application temperature 10 – 25 ºC.

https://www.jlmlubricants.com/en-au/products/jlm-underbody-coating

NOTE: This product cannot be shipped internationally

Hazard Documentation

https://cdn.shopify.com/s/files/1/0618/3675/5027/files/J04601_JLM_Underbody_Coating_2024_December_19_AUS_EN.pdf?v=1745377683